GDP Robot…
The final competition went better than expected. In each round we collected a minimum of one ball, and as seen above, once it even collected six balls, and it would have been seven if it had not jammed the spinner.
Thanks to all who participated - this is what the past six months has been about with regards to this module…
- Contactless Power Transfer…
- while(1){do_thesis;}
- The Final MARV…
- GDP Robot Testing…
- The chassis…
I found this online when googling about as the abstract for a patent: A flux generator base unit electromagnetically coupled with a receiving unit to transfer energy into the receiving unit. The ba...
The subject title says it all. There really isn't much to report apart from the fact that all the hard work gone into MARV culminated into a meeting with my thesis supervisor and a simple demonstrati...
This is a shot of the completed MARV. In the photograph below you can see that the 12V SLA has been mounted as well under the top plexiglass. The robot is now truly 'plug and play', and below ...
I just found this clip on my camera. The full group report was handed in on Friday......
This is going to be part of a new series of posts, covering my MSc project. Over the past couple weeks I have been planning the project and have also covered most of the ground work involving the i...